How To Turn On Bsd Rcta. 2019 subaru Outback Radar Back and Side. SYSTEM, BSD, RCTA 87611VA020 Release the claws and remove the BSD/RCTA OFF switch (f) This shows one of the common problems with all modern Subarus just because the placement of the RCTA sensors is not perfect
Lcw/rcta/bsd/aoa Blind Spot Front Reversing Lane Change Radar from www.alibaba.com
Checked the owner manual and found I was supposed to disable it myself when towing a trailer because the sensors get confused by the trailer behind (also in some other situations) Should be with the other switches to the left of the steering column.
Lcw/rcta/bsd/aoa Blind Spot Front Reversing Lane Change Radar
Then you will be able to do what is necessary (swap over wiring harness, install BSD indicator, etc). Checked the owner manual and found I was supposed to disable it myself when towing a trailer because the sensors get confused by the trailer behind (also in some other situations) To turn on bsd/rcta, press the bsd/rcta switch, which is typically located on the dashboard near the driver's side or on the rearview mirror
2019 subaru Outback Radar Back and Side. SYSTEM, BSD, RCTA 87611VA020. If you have a mirror turn signal, unscrew the 1 screw obviously securing it, and go back to the front of the mirror + pull tab up that is below the green circle farthest to the right Then you will be able to do what is necessary (swap over wiring harness, install BSD indicator, etc).
Lcw/rcta/bsd/aoa Blind Spot Front Reversing Lane Change Radar. WARNING The driver is responsible for driving safely. The manual (7-64; Starting and operating/BSD/RCTA) shows the location of the switch for turning it on/off